Cisco 352-001 ExamCCDE Written Exam

Total Question: 249 Last Updated: Jul 13,2019
  • Updated 352-001 Dumps
  • Based on Real 352-001 Exams Scenarios
  • Free 352-001 pdf Demo Available
  • Check out our 352-001 Dumps in a new PDF format
  • Instant 352-001 download
  • Guarantee 352-001 success in first attempt
Package Select:

Questions & Answers PDF

Practice Test Software

Practice Test + PDF 30% Discount

Price: $65.95 $39.99

Buy Now Free Trial

Top Pinpoint 352-001 secret Tips!

Master the 352-001 CCDE Written Exam content and be ready for exam day success quickly with this Testking 352-001 exam engine. We guarantee it!We make it a reality and give you real 352-001 questions in our Cisco 352-001 braindumps.Latest 100% VALID Cisco 352-001 Exam Questions Dumps at below page. You can use our Cisco 352-001 braindumps and pass your exam.

Q71. Which option is a BFD design consideration? 

A. BFD should not be used with RSVP-TE backup tunnels. 

B. BFD echo mode may reduce convergence time. 

C. BFD does not support sessions over MPLS LSPs. 

D. BFD is supported on indirectly connected peers. 

Answer:


Q72. You are designing a multisite VPN solution for a customer and you are concerned with the additional overhead of point-to-point tunnels and the associated overlay routing with DMVPN. How does a GDOI-based VPN eliminate the additional tunnel and routing overhead found in DMVPN? 

A. The GDOI-based VPN requires overlaying a secondary routing infrastructure through the tunnels. 

B. In a GDOI-based VPN, all group members share a common security association. 

C. The GDOI-based VPN requires the provisioning of a complex connectivity mesh. 

D. The GDOI-based VPN leverages the routing protocol to find its peer for tunnel setup. 

Answer:


Q73. Refer to the exhibit. 

Company A is running a single-area OSPF, and Company B is running RIP as the IGP with no overlapping IP address spaces. Company A has just acquired Company B and both networks must be merged. Which three design components are recommended to guarantee connectivity and redundancy between the two networks? (Choose three.) 

A. Enable mutual redistribution between OSPF and RIP on one border router. 

B. Enable mutual redistribution between OSPF and RIP on Router A and Router B using route tags. 

C. Increase the administrative distance to 130 for the OSPF external prefixes on Router A and Router B. 

D. Implement an ACL on Router A and Router B to prevent OSPF external routes from being installed in the OSPF database. 

E. Filter external routes on Router A and Router B based on route tags. 

Answer: BCE 


Q74. Which technique can you use to detect forwarding path failures at a uniform rate, and reconvergence times will be consistent and predictable when your routers are in the same broadcast domain? 

A. Enable BFD on your routers. 

B. Configure your routers with IP-SLA to ping the peer router. 

C. Configure your routers with IP-SLA and track to ping the peer and switch to a default route if the pings fail. 

D. Tune your routing protocol timers. 

Answer:


Q75. You are designing a network that includes IP QoS. Which two architectures could be used to ensure that IP QoS is implemented properly? (Choose two.) 

A. Differentiated Services, where the user, with the assistance of the RSVP signaling protocol, reserves the resources end to end before sending the data 

B. Integrated Services, where the user, with the assistance of the RSVP signaling protocol, reserves the resources end to end before sending the data 

C. Integrated Services, which relies on the information carried within each packet to make resource-allocation decisions at each network node 

D. Differentiated Services, which relies on the information carried within each packet to make resource-allocation decisions at each network node 

E. Integrated Services, where the user, with the assistance of the DSCP signaling protocol, reserves the resources end to end before sending the data 

Answer: BD 


Q76. Refer to the exhibit. 

You are designing a loop-free hierarchical VPLS service. Which two design considerations should be implemented for the pseudowires between the N-PE and U-PE routers? (Choose two.) 

A. Disable split horizon toward the N-PE routers. 

B. Disable split horizon toward the U-PE router. 

C. Enable split horizon toward the U-PE router. 

D. Enable split horizon toward the N-PE routers. 

E. Disable MAC learning on the U-PE route. 

F. Disable MAC learning on the N-PE routers. 

Answer: BD 


Q77. ACME Corporation is integrating IPv6 into their network, which relies heavily on multicast distribution of data. Which two IPv6 integration technologies support IPv6 multicast? (Choose two.) 

A. 6VPE 

B. 6PE 

C. dual stack 

D. ISATAP 

E. 6to4 

F. IPv6INIP 

Answer: CF 


Q78. You are designing an 802.11 wireless network to include a controller as a central configuration point and access points across several remote sites. Which two aspects will manage the flow of the traffic to meet these design considerations? (Choose two.) 

A. WLAN local switching with VLAN mapping requires that VLAN ID that is mapped on the AP to match a dynamic interface that is configured on the wireless LAN controller. 

B. Layer 3 roaming is not supported for locally switched WLANs. 

C. The 802.1x authentication for a client associated to an AP on a locally switched WLAN is always handled at the wireless LAN controller side. 

D. The access point can receive multicast traffic in the form of multicast packets from the WLC. 

E. WLAN access lists can be applied only to centrally switched WLANs. 

Answer: BE 


Q79. You are designing an Out of Band Cisco Network Admission Control, Layer 3 Real-IP Gateway deployment for a customer. Which VLAN must be trunked back to the Clean Access Server from the access switch? 

A. untrusted VLAN 

B. user VLAN 

C. management VLAN 

D. authentication VLAN 

Answer:


Q80. You are tasked to design a QoS policy for a service provider so they can include it in the design of their MPLS core network. If the design must support an MPLS network with six classes, and CEs will be managed by the service provider, which QoS policy should be recommended? 

A. map DSCP bits into the Exp field 

B. map IP precedence bits into the DSCP field 

C. map flow-label bits into the Exp field 

D. map IP CoS bits into the IP Precedence field 

E. map IP ToS bits into the Exp field 

Answer:


Related 352-001 Articles