Cisco 300-207 ExamSITCS Implementing Cisco Threat Control Solutions (SITCS)

Total Question: 242 Last Updated: Jun 13,2019
  • Updated 300-207 Dumps
  • Based on Real 300-207 Exams Scenarios
  • Free 300-207 pdf Demo Available
  • Check out our 300-207 Dumps in a new PDF format
  • Instant 300-207 download
  • Guarantee 300-207 success in first attempt
Package Select:

Questions & Answers PDF

Practice Test Software

Practice Test + PDF 30% Discount

Price: $65.95 $29.99

Buy Now Free Trial

Top 10 testing software 300-207 for examinee (21 to 30)

Exambible 300-207 Questions are updated and all 300-207 answers are verified by experts. Once you have completely prepared with our 300-207 exam prep kits you will be ready for the real 300-207 exam without a problem. We have Far out Cisco 300-207 dumps study guide. PASSED 300-207 First attempt! Here What I Did.

Q21. Over the period of one day, several Atomic ARP engine alerts fired on the same IP address. You observe that each time an alert fired, requests on the IP address exceeded replies by the same number. Which configuration could cause this behavior? 

A. The reply-ratio parameter is enabled. 

B. MAC flip is enabled. 

C. The inspection condition is disabled. 

D. The IPS is misconfigured. 

Answer:


Q22. Which two conditions must you configure in an event action rule to match all IPv4 addresses in the victim range and filter on the complete subsignature range? (Choose two.) 

A. Disable event action override. 

B. Leave the victim address range unspecified. 

C. Set the subsignature ID-range to the default. 

D. Set the deny action percentage to 100. 

E. Set the deny action percentage to 0. 

Answer: B,C 


Q23. Which Cisco ASA configuration command drops traffic if the Cisco ASA CX module fails? 

A. no fail-open 

B. fail-close 

C. fail-close auth-proxy 

D. auth-proxy 

Answer:


Q24. Which two commands are used to verify that CWS redirection is working on a Cisco ASA appliance? (Choose two.) 

A. show scansafe statistics 

B. show webvpn statistics 

C. show service-policy inspect scansafe 

D. show running-config scansafe 

E. show running-config webvpn 

F. show url-server statistics 

Answer: A,C 


Q25. A Cisco Email Security Appliance uses which message filter to drop all executable attachments entering and leaving the Cisco Email Security Appliance? 

A. drop-exE. if (attachment-filename == "\\\\.exe$") OR (attachment-filetype == "exe") { drop(); } 

B. drop-exE. if (recv-listener == "InboundMail" ) AND ( (attachment-filename == "\\\\.exe$") OR (attachment-filetype == "exe")) { drop(); } 

C. drop-exe! if (attachment-filename == "\\\\.exe$") OR (attachment-filetype == "exe") { drop(); } 

D. drop-exe! if (recv-listener == "InboundMail" ) AND ( (attachment-filename == "\\\\.exe$") OR (attachment-filetype == "exe")) { drop(); } 

Answer:


Q26. Which Cisco technology combats viruses and malware with virus outbreak filters that are downloaded from Cisco SenderBase? 

A. ASA 

B. WSA 

C. Secure mobile access 

D. IronPort ESA 

E. SBA 

Answer:


Q27. What are three features of the Cisco Security Intellishield Alert Manager Service? (Choose three.) 

A. validation of alerts by security analysts 

B. custom notifications 

C. complete threat and vulnerability remediation 

D. vendor-specific threat analysis 

E. workflow-management tools 

F. real-time threat and vulnerability mitigation 

Answer: A,B,E 


Q28. Which command verifies that the correct CWS license key information was entered on the Cisco ASA? 

A. sh run scansafe server 

B. sh run scansafe 

C. sh run server 

D. sh run server scansafe 

Answer:


Q29. Which Cisco ESA predefined sender group uses parameter-matching to reject senders? 

A. BLACKLIST 

B. WHITELIST 

C. SUSPECTLIST 

D. UNKNOWNLIST 

Answer:


Q30. Which command sets the number of packets to log on a Cisco IPS sensor? 

A. ip-log-count number 

B. ip-log-packets number 

C. ip-log-bytes number 

D. ip-log number 

Answer:


Related 300-207 Articles